Attaching The Center Slide Bar To The Bsu; Installing The Rack Mounting Bracket Assemblies Into The Rack Cabinet - NEC EXPRESS5800/180Ra-7 User Manual

Attaching the Center Slide Bar to the BSU

Using the two center slide bars removed in the previous procedure attach them
to the BSU as follows:
1. Align the mounting holes in each slide bar to the threaded holes on the side
of the BSU (see Figure 2-3).
Note:
one way with the holes in the BSU.
2. Secure each slide bar to the BSU using four screws, as shown in Figure 2-3
Figure 2-3. Attaching the Inner Component Slide Bar to the BSU

Installing the Rack Mounting Bracket Assemblies into the Rack Cabinet

Before you can mount the BSU in the rack cabinet, you must install the Rack
Mounting Bracket Assemblies in the rack cabinet.
Note:
the rack cabinet before mounting the BSU into it. Observe all
safety precautions, warnings, and cautions noted throughout
this chapter.
Use the following procedure to install the Rack Mounting Bracket Assemblies
into the rack cabinet.
1. Determine where you want to install the BSU in the rack cabinet.
The holes in the two center slide bars line up only
A – Center Slide Bar
B – Safety Latch
C – Screws (1 of 4)
D – Threaded Holes in BSU
You must use the following procedure to prepare
Setting Up the System 2-7