NEC Univerge SV9100 System Hardware Manual page 521

Issue 3.0
SV9100 System Hardware Manual
6.1.1 Installing the Base Unit
Attach the Base Unit to the stand pegs, and connect the USB connector to a
free USB port on your computer. A USB hub can be used, if you are certain
that it can supply the required 250mA to charge the headset. An optional
AC power adapter can be installed in the AC Power Adapter Port.
6.1.2 Installing the PerSonoCall Software
To install the software, insert the CD supplied with the unit. If the CD does
not autoplay, use Windows Explorer to find the file called install.bat, double
click on it, and follow the instructions on the screen.
6.1.3 Charging the Headset Battery
To charge the headset battery, place it in the docking cradle. During
charging, the charge indicator is On. When charging is complete the
indicator goes Off. The headset must be charged for a minimum of one hour
before use – three hours to fully charge.
6.1.4 Initial Setup
The Unit includes a base ringer to provide notification of an incoming call
when not wearing your headset. This feature is enabled when the Ringer
switch is down and is disabled when the switch is up.
When the headset is installed, it sets itself as the default device in your
computer. You can set your preferences manually in Windows through the
Sounds and Audio Devices option in the control panel. A softphone may
require choosing the audio device and carries out a short test to match this
device to the softphone. It may also enable you to choose which device
indicates an incoming call. Refer to the softphone documentation for more
information.
6.1.5 Using the Headset
Refer to the User Guide for operating procedures.
6-43