NEC Univerge SV9100 System Hardware Manual page 62

Issue 3.0
TELEPHONE/SERVICE PROVIDER COMPANY NOTIFICATION
Before connecting this telephone system to the telephone network, the following information must be
provided to the telephone company:
Your telephone number.

FCC registration number:

When the SV9100 system is to be installed as a Key Function system (no dial access to Trunk

Groups/Route Advance Blocks), use the following number:
US:NIFKF07BSN1750
When the SV9100 system is to be installed as a Multifunction system, use the following number:

US:NIFMF07BSN1750
When the SV9100 system is to be installed as a PBX system, use the following number:

US:NIFPF07BSN1750
Ringer Equivalence Number (REN): 0.7B
USOC jacks required: RJ11C, RJEX, RJ2FX, RJ2HX, RJ48C, RJ21X
INCIDENCE OF HARM
If this equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. But if advance notice is not
practical, the telephone company will notify the customer as soon as possible. Also, you will be advised
of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this happens, the telephone company will provide advance
notice in order for you to make necessary modifications to maintain interrupted service.
REPAIR SERVICE REQUIREMENTS
If the equipment is causing harm to the telephone network, the telephone company may request that you
disconnect the equipment until the problem is resolved.
If equipment malfunctions, all repairs must be performed by an authorized agent of NEC Corporation of
America. The user requiring service is responsible for reporting the need for service to an NEC
Corporation of America authorized agent or to NEC Corporation of America.
R-2