Figure 9-49 User Interface Tab Options - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
SV9100 System Hardware Manual
5. Run Setup.exe on your NEC Installation CD to install the Voice
Security Recorder application software on your PC.
6. Using the USB cable provided, connect the USB interface of the NEC
call logging unit to an available USB port on your PC.
7. Unplug the line cord from your telephone and connect the phone to
either port on the call logging unit.
8. Connect the NEC telephone system to the remaining port on the NEC
1-Port Digital Logging Unit (refer to
Connection on page
12.1.5 Call Logging Application Software
The software is delivered on a Compact Disk using a self-starting install
shield. The CD contains all applicable files and installation procedures to
operate to this specification, including USB device drivers, software
application, and Help files.
A quick-start instruction sheet and a recorded user guide that steps the user
through the various options are provided.
The application supports Microsoft Operating Systems that support USB
devices. The following systems meet this requirement:
Windows XP (all variants)

Windows 7 (32- and 64-bit)

12.1.6 Call Logging User Interface Tab Options
The call logging unit has the following tabs to allow the user to select
features and options:
Playback allows various playback features of recorded conversations.

Record allows control of recording.

About provides software version information.

Options to set-up controls such as recording format.

File Management allows the user to manage disk space used by the

call logging unit.

Figure 9-49 User Interface Tab Options

Figure 9-59 Digital Call Logger
9-74).
9-65