Table 8-1 Sip Conference Max Keypad Functions - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
2.2
2.3
SV9100 System Hardware Manual
Connecting and Charging the Batteries
To connect and charge the batteries:
1. Slide the cover off the battery compartment on the bottom of one pod.
2. Connect the battery pack plug in the port in the compartment and install the
battery pack.
3. Slide the cover back in place.
4. Connect the power supply/charger to the conferencing pod and plug it in an
electrical outlet.
Charge batteries for 15 hours prior to first use.
IMPORTANT
5. Repeat steps 1~4 for the other pod.
Keypad Functions
Refer to Table 8-1 SIP Conference Max Keypad

Table 8-1 SIP Conference Max Keypad Functions

Key
ON/OFF key
(telephone icon)
PHONEBOOK (book
icon)
REDIAL (circular arrow
icon)
CONFERENCE (three
person icon)
FLASH (lightning flash
icon)
CLEAR (vertical line
and left arrow icon)
VOLUME (loud and dim
speaker icons)
MUTE (mic with
diagonal line icon)
Press to activate the telephone and access dial tone. Press
again to hang up and return to standby mode.
Press to dial stored numbers. Press and hold two seconds to
enter Phonebook Edit mode.
Press once to dial the last number called. Press and hold two
seconds to enter Program mode.
Press to dial the conferencing service provider. This feature
must be programmed.
Press to enable call forwarding, call waiting, or three-way
calling when supported by telephone service.
Press to clear the last digit entered or press and hold to clear all
numbers.
Press to exit programming mode.
Press during call to adjust call volume or press while telephone
is ringing or in standby mode to adjust ringer volume.
Press to mute sound.
Functions.
Function
8-3