Table 4-6 Gcd-Cp10 Switch Settings; Table 4-7 Gcd-Cp10 Switch 4/6 Settings - NEC Univerge SV9100 System Hardware Manual

4-22
3.1.3 Switch Settings
Refer to

Table 4-6 GCD-CP10 Switch Settings

reset and with system power on.
page 4-15 shows the location of the LOAD (S5) switch on the GCD-CP10
blade.
Table 4-6 GCD-CP10 Switch Settings
USB Memory Status
With a system restart or a system reset while holding
the LOAD (S5) switch:
When USB Memory is not
Switch installed:
S5 – LOAD
When USB Memory is
Switch
installed:
When an unauthorized USB
device is installed:

Table 4-7 GCD-CP10 Switch 4/6 Settings

SW4-1
SW4-2
SW4-3
SW4-4
S6
Figure 4-6 GCD-CP10 Blade Layout on
Cold Start occurs.

USB Memory contents loaded.
System does not start and an
Illegal USB device is connected
alarm is recorded.
Configuration
ON Not Used
OFF Test Mode
ON = Test Mode
OFF = Normal
OFF RS232C Select
ON = Use
OFF = Not Used
ON Reset Configuration
ON = Normal
OFF = ICE Mode
SENSE Switch Not Used
Issue 3.0
for system restart/system
Operation
Database default occurs
Notes
Installing the SV9100 Blades