NEC Univerge SV9100 System Hardware Manual page 707

Issue 3.0
13.7 IPv6 Adapter and Concentrator Solution
SV9100 System Hardware Manual
Figure 9-146 GBA-L UNIT LED Display
When 1000Mbps is
LED Name
Connected
SPEED Display Green Lighting
LED Name
LINK/ACT Display
NEC's IPv6 Adapter and Concentrator solutions main objective is supporting
IPv4-only DT700 Series terminals and IPv4-only NEC SV9100 PBX in an IPv6-
only network. The solution accomplishes this objective by using SSL VPN tunnels
between the DT700 terminals and the NEC PBX. NEC offers two possible
deployment scenarios; both utilize the VPN in bridge-mode, meaning the DT700
terminal's IP address will be in the same subnet as the LAN to which the IPv6
Concentrator is connected. Bridge-mode also means that the DT700 series
phone's VLAN tagging and packet QoS information is retained across the VPN.
System Power
The NEC Concentrator chassis is typically mounted in a 19" rack and powered by
a standard 120vac power source.
The IP6-L Adapter snaps onto the back of NEC's DT700 Series VoIP phones and
draws electrical power from the telephone.
When 100Mbps is
Connected
Red Lighting
At LINK
(At the Data Communication)
Green Lighting
When 10Mbps is
Connected
Turning Off
ACT
Green Blinking
9-151