Installing A 60-Button Dss Console To An Ip Terminal - NEC UX5000 Hardware Manual

Chapter 4 - Telephones and Optional Equipment
5. Place the DSS side panel onto the side of the keyset and screw into place using the 3 screws provided.
6. Slide the DSS Console over the DSS side panel until it clicks into
place.
7. Secure the console to the side panel using the 2 screws provided.
8. Connect a line cord from the modular jack to the RJ11 connector on
the bottom of the DSS console.
9. Route the line cord cable through the cable guide on the bottom of the console.
4.5.3

Installing a 60-Button DSS Console to an IP Terminal

1. The console can be physically attached to the keyset. First, remove the
right side panel from the keyset (or 16-Button Line Key Module, if
installed). Hook a finger on the hollow indent on the back of the telephone
(near the top) and gently pull off the panel.
2. Place the DSS side panel onto the side of the keyset and screw into place
using the 3 screws provided.
4 - 18 Chapter 4