Figure 6-26 Base Coverage Area - NEC Univerge SV9100 System Hardware Manual

6-20
3.2.2 Map the Base Coverage Area
To find the best location for the repeater, you need to determine the base
coverage area. Stand near the base and make a call. Walk away from the
base with the handset, and make a note where the signal becomes weaker.
The optimum location for the repeater is as far from the base as possible
while still maintaining a good signal, or just inside the location where the
signal became weaker.

Figure 6-26 Base Coverage Area

3.2.3 Test the Location
To test the location, plug the AC adapter into the repeater, then hold the
repeater in the place where you plan to mount it. The LED should remain on
and steady, indicating that the repeater has a good signal from the base.
If the LED flashes, the repeater is not getting a good signal. The repeater
may be too far away from the base, there may be interference from
electronic devices, or the signal might be blocked by thick walls or metal
objects. Try moving the repeater to another location.
Issue 3.0
Installing SV9100 Cordless Telephones