Figure 9-112 Apr-L Unit - NEC Univerge SV9100 System Hardware Manual

9-130
13.4.1 APR-L UNIT Switch Settings

Figure 9-112 APR-L UNIT

switches (DSW) allow a technician to configure the unit for specific settings.
TIP
Set the DIP switches on the APR adapter to the required position.
Figure 9-112 APR-L UNIT
ANALOG PORT
13.4.2 Installing the APR-L UNIT
Perform the following to connect the APR-L UNIT to the Bottom Option
Interface located underneath the DTL multiline terminal.
IMPORTANT
WARNING
1. Unplug the line cord from the multiline terminal.
2. Turn the DTL multiline terminal upside down.
3. Lower the tilt leg to the first position (refer to
Tilt Leg from Leg Support on page
shows the location of the switches. The DIP
Due to the location of the switches, set switches prior to
installation of ADA-L UNIT on DTL/ITL multiline terminal.
Only ONE APR-L UNIT can be installed.
To prevent possible damage to the APR-L UNIT or the DTL
multiline terminal during installation or removal, disconnect
the line cord/LAN cable and the AC/DC adapter from the
DTL multiline terminal.
9-131).
Installing SV9100 Optional Equipment
Issue 3.0
Figure 9-113 Separate