Attaching The Center Slide Bar To The Server; Installing The Rack Mounting Bracket Assemblies Into The Rack Cabinet - NEC EXPRESS5800/140Hb Service Manual

Attaching the Center Slide Bar to the Server

Using the two center slide bars removed in the previous procedure attach them
to the server as follows:
1. Align the mounting holes in each slide bar to the threaded holes on the side
of the server (see Figure 2-3).
Note:
one way with the holes in the server.
2. Secure each slide bar to the server using three M4 screws, as shown in
Figure 2-3
Figure 2-3. Attaching the Inner Component Slide Bar to the server

Installing the Rack Mounting Bracket Assemblies into the Rack Cabinet

Before you can mount the server in the rack cabinet, you must install the Rack
Mounting Bracket Assemblies in the rack cabinet.
Note:
the rack cabinet before mounting the server into it. Observe
all safety precautions, warnings, and cautions noted
throughout this chapter.
Use the following procedure to install the Rack Mounting Bracket Assemblies
into the rack cabinet.
1. Determine where you want to install the server in the rack cabinet.
The holes in the two center slide bars line up only
A – Center Slide Bar
B – Safety Latch
C – M4 Screws (1 of 3)
D – Threaded Holes in server
You must use the following procedure to prepare
Setting Up the System 2-7