NEC Univerge SV9100 System Hardware Manual page 340

4-90
6.1.3.2 Busy LED – Red
The Busy LED is controlled by the DSP and indicates the port
status.


6.1.3.3 Application LED – Red/Green (Dual Color)
The Application LED is controlled by the DSP indicates the
state of the software running on the





6.1.3.4 CompactFlash Card Activity LED – Red
The CompactFlash Card Activity LED is controlled by the IDE
controller and indicates read/write activity on the CompactFlash
card.
6.1.4 Connectors
The following sections go into detail on each user interface.
6.1.4.1 RS-232 Interface
The RJ-11 connector with DB9 adapter (part number 1091014)
is used for connection to an external PMS Application or the
PMS-U10. The cable used for a PC type DTE connection is a
standard line cord shown in
Serial Cable (DTE) on page
device uses the swapped line cord shown in
GCD-VM00 RS-232 Serial Cable (DCE) on page
Off: Power off or idle.
On: Reset.
Off: Power off.
Solid Red/Green (Yellow): Reset.
Flashing Green: OS is running, application not started.
Solid Green: Application running.
Solid Red: Application problem.
Figure 4-37 GCD-VM00 RS-232
4-91. The connection for a DCE
Issue 3.0
APSU
.
Figure 4-38
4-92.
Installing the SV9100 Blades