Figure 6-3 Connecting Telephone Cords To The Telephone Jack - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
2.3
SV9100 System Hardware Manual
Connecting the Telephone Cords
When connecting the telephone cords, observe the following precautions.
Never install telephone wiring during a lightning storm.
❍
Never touch bare telephone wires or terminals unless the telephone
❍
WARNING
line is disconnected at the network interface.
Use caution when installing or modifying telephone lines.
❍
To connect the telephone cords:
1. Connect the cord from the telephone jack to the Line In on the D
Cordless DECT.

Figure 6-3 Connecting Telephone Cords to the Telephone Jack

2. Connect a qualified NEC digital multiline terminal to the D
DECT (refer to Figure 6-4 Connecting the D
Multiline Terminal on page
term
Cordless DECT to the
6-4).
term
term
Cordless
6-3