NEC Univerge SV9100 System Hardware Manual page 345

Hide thumbs Also See for Univerge SV9100:

Table of Contents

SV9100 System Hardware Manual

Basic Support Package

Each blade installed with the PVA PMS or IVR package accounts for up to

16 Extension Ports of the Total Port capacity (One PVA PMS or One IVR

blade maximum). Each CCISoIP package can be licensed for up to 24 ports

and counts towards total trunk port capacity.

Refer to the following tables for maximum upgrade capacities of the

GCD-PVAA blade:

Table 2-6 SV9100 Maximum 9.5" Gateway and 19" System

Capacities – Blades on page 2-12

Table 2-7 SV9100 Maximum 9.5" Base and Expansion System

Capacities – Blades on page 2-14

Installation

To install the GCD-PVAA:

Install CompactFlash on GCD-PVAA

Plug the blade into any universal slot on the chassis

Refer to Program 10-55-01 to configure the IP Address of the

Refer to Program 10-55-04 to configure the Subnet Mask of the

Refer to Program 10-55-05 to configure the Gateway of the

The GCD-PVAA blade is hot swappable and can be removed from

the chassis without powering down the blade or the SV9100 system

When the SV9100 requires system reset, this blade comes back on

Switch Settings

The GCD-PVAA blade has the following switches:

Reset Switch SW3

This switch allows the technician to reset the GCD-PVAA without

having to remove and reinsert the blade into the chassis.

Chapters

Table of Contents