Figure 6-11 Inserting Screws Into The Wall For Wall Mounting The Telephone - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Mounting the Base Directly to the Wall

If a standard wall plate is not available, mount the telephone directly on the wall.

Before mounting the telephone, consider the following:

Select a location away from electrical cables, pipes, or other items behind the

mounting location that could cause a hazard when inserting screws into the

Make sure the wall material can support the weight of the base unit.

Use #10 screws with anchoring devices suitable for the wall material where the

base unit will be placed.

To mount the telephone:

Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an

inch between the wall and screw heads for mounting the telephone.

Figure 6-11 Inserting Screws into the Wall for Wall Mounting the Telephone

Plug in and secure the AC adapter.

Plug the AC adapter into the base unit.

Plug one end of the short telephone cord into the LINE jack on the base

unit. Then plug one end of an NEC multiline terminal into the PHONE jack.

Place the telephone cords inside the molded channels on the bottom of the

wall mount stand (refer to

the Wall Mount Stand on page

Figure 6-12 Placing the Telephone Cords Inside

Installing SV9100 Cordless Telephones

Table of Contents