Figure 6-32 Separate Tilt Leg From Leg Support - NEC Univerge SV9100 System Hardware Manual

4.4
6-28
Installing the Bluetooth Cordless Handset
The BCH-L (BK) UNIT is an optional device that transforms the standard
multifunction telephone into a cordless terminal. This section explains how to
transform the standard hand-set into a BCH-L (BK) UNIT. The BCH-L (BK) UNIT
cannot be connected to the DTL-2E-1, DTL-6DE-1 or DTL-12-E-1 telephones.
4.4.1 Installing the Bluetooth Handset Cradle
WARNING
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline terminal.
Only one BCH-L (BK) UNIT can be attached to the DTL multiline

terminal.
3. Lower the tilt leg to the first position (refer to
Leg from Leg

Figure 6-32 Separate Tilt Leg from Leg Support

Tilt Leg
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and pull
the legs toward you, lifting to remove (refer to
Legs From Multiline Terminal on page
Before installing or removing the BCH-L (BK) UNIT, remove
the line cord and the AC adapter from the outlet.
Support).
Installing SV9100 Cordless Telephones
Issue 3.0
Figure 6-32 Separate Tilt
Stoppers
Figure 6-33 Remove
6-29).