Figure 5-85 Removing Numbered Keypad From Dt300/Dt700 Series Terminal; Figure 5-86 Install New Numbered Keypad Into Dt300/Dt700 Series Terminal - NEC Univerge SV9100 System Hardware Manual

5-80
2. Pull down on the tab and lift the Numbered Keypad away
from the telephone to remove the existing button. Refer to
Figure 5-85 Removing Numbered Keypad from DT300/
DT700 Series
Figure 5-85 Removing Numbered Keypad from DT300/DT700
5.2.6.2 Installing the Numbered Keypad
1. Slide the replacement numbered keypad into the grooves
located on the inside of the telephone, then press down on
the keypad to snap it into place. Refer to
New Numbered Keypad into DT300/DT700 Series
Figure 5-86 Install New Numbered Keypad into DT300/DT700
Installing DT Series Digital and IP Multiline Terminals
Terminal.
Series Terminal
Series Terminal
Issue 3.0
Figure 5-86 Install
Terminal.