Figure 5-32 Installing The Handset (Dt300) - NEC Univerge SV9100 System Hardware Manual

Issue 3.0
S 4 I
ECTION NSTALL
4.1
SV9100 System Hardware Manual
M T
ULTILINE ERMINALS
Connecting the DT300/DT400 Series Multiline Terminal to the
System
This instruction applies to all DT300/DT400 series multiline terminals.
4.1.1 Connecting the Handset
Confirm the location of the handset connector
multiline terminal. Then, connect the handset to the multiline terminal
using the steps shown below.
4.1.1.1 Handset Connection DT300
1.
2.

Figure 5-32 Installing the Handset (DT300)

4.1.1.2 Handset Connection DT400
1.
2.
Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
Lead the Handset cable through the applicable groove.
Refer to Figure 5-32 Installing the Handset
Install the modular plug (attached to the curl cord of the
handset) into the handset connector at the back of terminal.
Push until it snaps into place.
Lead the Handset cable through the applicable groove.
Refer to Figure 5-33 Installing the Handset (DT400) on page
5-46.
on the bottom of the
(DT300).
5-45