NEC Univerge SV9100 System Hardware Manual page 495

Issue 3.0
3.1
SV9100 System Hardware Manual
Setting Up Your Repeater
Before installing the repeater, you must activate the repeater mode on your base
and then register the repeater to the base and any handsets. Before you start the
registration process, be sure you have:
A working base

A working handset registered to that base

Any repeaters you want to register to this base (you must complete the

registration process separately for each repeater)
At least one of the AC adapters supplied with the repeaters

Use ONLY the power adapter that came with your repeater. A different
power adapter may cause an electrical hazard or damage the repeater.
WARNING
3.1.1 Changing the Telephone System PIN
Before you start the registration process, you must reset the system PIN of
your telephone to 0000 (consult the manual that came with your base for
more information). After you reset the PIN, make sure to register the
handset you used back to the base station.
3.1.2 Automatic Registration
The repeater seeks out the base with strongest DECT/GAP signal and
automatically registers to that base.
1. Make sure the repeater is powered off (i.e., the AC power adapter is
not connected).
2. Set the base in registration mode. (Consult the owner's manual that
came with your base station for more information.
3. Use the AC adapter to connect the repeater to a standard 120 V AC
outlet. (Do not use a power outlet controlled by a wall switch.) The
LED on the repeater flashes briefly, then remains on and steady.
If the LED continues to flash, register the repeater again.

The repeater is now registered to this base and is ready to use.
You can safely disconnect the power and move the repeater to the selected
location; the repeater stays registered to the base.
6-17