Figure 9-14 Gcd-Cp10 Page Connections - NEC Univerge SV9100 System Hardware Manual

Hide thumbs Also See for Univerge SV9100:

Table of Contents

SV9100 System Hardware Manual

Install a modular jack for each PGD(2)-U10 ADP. For each module,

run one-pair 24 AWG station cable from the cross-connect block to a

modular jack. Ground the unused pair.

Terminate the extension leads to GRN/RED of the modular jack.

Terminate the unused leads to the jack.

Install bridging clips as required.

Plug a modular line cord from the mod jack to the CN1 connector on

the PGD(2)-U10 ADP.

Connect the two-conductor station cable from the CN5 connectors in

the PGD(2)-U10 ADP to the external relay.

Figure 9-14 GCD-CP10 Page Connections

External Recording System or External Ringer

The PGD(2)-U10 ADP allows the connection of an external recording system or

external ringer. With a customer-provided tape recorder, when an extension user

dials the ACI analog port extension number, they can automatically start the

recorder and activate the record function. When the user hangs up, the recording

stops and the tape recorder turns off. For tape recording, connect the tape

recorder AUX input jack to the PGD(2)-U10 ADP jack. Connect the recorder

control leads (if available) to the CTL (control relay) jack. By using Department

Calling, you can arrange multiple tape recorders into a pool. When an extension

user dials the Department Group pilot number, they reach the first available tape

recorder in the pool.

The relay closes when the Door Box/external page

zone is called. The maximum applied voltage is 24vDC

at .5A for each contact.

Table of Contents