NEC Univerge SV9100 System Hardware Manual page 528

2.1
2.2
7-2
Installation
The hardware installation consists of the following steps:
1. Determine the number of DAPs that need to be installed and where they
should be located. Refer to NEC SIP DECT Solutions Technician's Guide,
DAP Planning as a guideline.
2. Read the sections
DECT Solutions Technician Guide carefully to determine how the DAPs
should be powered and how the cable must be run.
3. Make sure that you have an IP Switch available to connect the IP DECT
equipment. Power up the IP Switch.
4. Setup and connect the power provision for the DAPs. The LEDs on the
DAPs should show some activity.
5. Connect the DAP cables to the IP Switch.
CAUTION
6. Make sure that you have a computer available that can be used for
management. Connect this PC to the IP Switch using an Ethernet cable.
Check that the lamp on the IP Switch indicates that the connection is
established.
7. (For UNIVERGE SV9100 only) Connect a network cable between the
GPZ-IPLE and the IP Switch.
8. The next step is setting up your IP Addressing structure. Refer to the NEC
SIP DECT Solutions Technician's Guide, IP Addressing.
Handsets
The following are available to the SIP DECT system:
DAP Cabling and DAP Power Provision in the
Do Not connect the Ethernet cables or the IP Switch to the local
IP network. The DECR configuration should be installed in a
closed network.
Issue 3.0
NEC SIP
Installing SV9100 Wireless Telephones