NEC Univerge SV9100 System Hardware Manual page 601

Issue 3.0
SV9100 System Hardware Manual
11.5.6 Installation
WARNING
11.5.6.1 Location Preparation
The wiring for the extensions should be within six feet of the PC
location. For this reason, the PC for the NEC BackOffice
Recorder should be located near the MDF for extension wiring.
The installer must prepare the wiring to tap off the digital pair
with a T-Connect type setup.
It may be desirable to fasten the devices to a PC or rack. Since
the devices are lightweight, this can be done quite easily with
Velcro tape.
11.5.6.2 Set Up PC
WARNING
1.
2.
3.
4.
5.
6.
DO NOT install the NEC BackOffice Software until
instructed! It is critical that you follow the steps in the
installation procedure in the order listed below. Failure to do
so results in an unsuccessful installation.
DO NOT connect more than four of the 4-Port
Digital Call Logging Unit devices to each USB
Controller Card.
Set up the PC with the appropriate number of USB
Controller Cards and/or USB hubs. Follow the installation
instructions for the Controller Card carefully. The PC should
be connected to the LAN for supervisor access and to
facilitate Windows and software updates as needed. It may
be desirable also to load PC Anywhere on the PC for remote
administration of the application.
After USB cards are installed, go to
www.windowsupdate.com. Download and install any
updated device driver that may be available for WIN2000 or
XP and your USB Controller Cards. This is very important,
as WIN2000 does not always have the required device
drivers loaded in default for USB 2.0 devices. If your card
came with a driver CD this step may have been taken care
of during installation of the card.
Update Windows 2000 to Service Pack 4; this is available as
a free upgrade from the Windows update web site.
When all USB Controller Cards are installed and the PC
updated, restart the PC.
Connect any USB hubs if applicable.
The brand or type of USB hub must match
that of the USB Controller Card.
CAUTION
After USB hubs are installed, restart the PC again.
9-45