Chapter 2 Finisher Unit Basic Operation; Basic Operation; Outline - Canon FINISHER-C1 Service Manual

I. BASIC OPERATION
A.

Outline

The finisher is designed to deliver copies arriving from its host copier, and its modes of delivery
include simple stacking, job offset, staple, and interrupt.
All operations involved in these modes are controlled by the finisher controller PCB, according
to the appropriate commands from the host copier.
In the case of the Saddle Finisher-C2, copies from the host copier may be routed to the saddle
stitcher unit.
Note:
The term job offset refers to shifting of the first sheet of each sorting job, thereby separating a single
stack into several stacks.
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)

CHAPTER 2 FINISHER UNIT BASIC OPERATION

Swing guide drive system
Alignment drive system
Stapler drive system
Delivery drive system
Feeder drive system
Shutter drive system
Tray drive system
Saddle stitcher unit control system
Figure 2-101
2-1