Adjustment At Poor Tray Stackability (When The Upper Curl Occurs) - Canon Finisher-AB1 Service Manual

Chapter 5
5.3.2.17 Adjustment at poor tray
stackability (when the upper curl
occurs)
This adjustment is performed either when poor tray
stackability occurs (when the upper curl occurs)
shown in the figure below or when the EEPROM
(IC107) on the finisher controller PCB is replaced.
F-5-116
<Memo>
By executing this adjustment, the finisher increases
the feeding speed when the trailing edge of paper
reaches to the delivery roller. The tray stackability is
thereby improved since no sheets are left in place
near the delivery exit.
Details of the adjustment procedure are provided
below.
1) Turn on the finisher.
2) Turn on the host machine so that the machine will
be in a standby state.
3) Open the front door, and insert the door switch
actuator into the door switch [1].
F-5-117
4) Remove the screw [2], and detach the switch
cover [1].
5-36
0016-6227
5) Set the DIP switch SW382 [1] on the switch PCB
as follows:
SW382
SW381
SW383
(-)
[1]
[1]
[2]
F-5-118
[1]
SW384 SW385
(+) ENTER
F-5-119