Adjusting The Angle Of The Aligning Plate (Orthogonal) - Canon Finisher-AB1 Service Manual

5.3.2.2 Adjusting the Angle of the Aligning
Plate (orthogonal)
Go through the following steps if you have replaced
the alignment motor of the intermediate handling
tray assembly or the EEPROM of the finisher
controller PCB:
1) After mounting the intermediate handling tray
assembly, loosen the 2 screws [2] on the aligning
plate [1] of the assembly.
[2]
F-5-28
2) Fix the 2 paper edge stoppers [1] in place on the
host machine using 2 screws [2].
F-5-29
[1] [2]
[2]
[1]
3) Place A4 paper [1] in the intermediate handling
tray in the direction of the arrow. Make adjustments
so that there is no gap between the paper edge [1] and
the aligning plate [2]; then, fix the aligning plate
0015-2226
using a screw [3].
[3]
Before
adjustment
[2]
After
adjustment
[2]
Chapter 5
[C]
[1]
[1]
F-5-30
[1]
5-11