Negotiation - SMC Networks 6824MPE INT Management Manual

negotiation

Use this command to enable autonegotiation for a given interface. Use the
no form to disable autonegotiation.
Syntax
[no] negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• When auto-negotiation is enabled the switch will negotiate the best
settings for a link based on the capabilities command. When
auto-negotiation is disabled, you must manually specify the link
attributes with the speed-duplex and flowcontrol commands.
• If autonegotiation is disabled, auto-MDI/MDI-X pin signal
configuration will also be disabled for the RJ-45 ports.
Example
The following example configures port 11 to use autonegotiation
Console(config)#interface ethernet 1/11
Console(config-if)#negotiation
Console(config-if)#
negotiation (4-177)
speed-duplex (4-175)
I C
NTERFACE OMMANDS
4-177