Snmp-Server Enable Traps - SMC Networks 6824MPE INT Management Manual

C L
OMMAND INE
Example
Console(config)#snmp-server host 10.1.19.23 batman private version 2c
udp-port 162
Console(config)#
Related Commands

snmp-server enable traps (4-162)

snmp-server enable traps
Use this command to enable this device to send Simple Network
Management Protocol traps (SNMP notifications). Use the no form to
disable SNMP notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
• authentication - Keyword to issue authentication failure traps.
• link-up-down - Keyword to issue link-up or link-down traps.
The link-up-down trap can only be enabled/disabled via the CLI.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
• If you do not enter an snmp-server enable traps command, no
notifications controlled by this command are sent. In order to configure
this device to send SNMP notifications, you must enter at least one
snmp-server enable traps command. If you enter the command with
no keywords, both authentication and link-up-down notifications are
enabled. If you enter the command with a keyword, only the notification
type related to that keyword is enabled.
4-162
I
NTERFACE