Charge Pressure/Temperature Sensor - Detroit Diesel MBE 4000 Service Manual

Hide thumbs Also See for MBE 4000:

Table of Contents

www.rtrucks.ru

CHARGE PRESSURE/TEMPERATURE SENSOR

Perform the following procedures for removal and installation of the charge pressure/temperature

Remove the charge pressure/temperature sensor as follows:

1. Apply the parking brakes, shut down the engine, and chock the rear tires. Tilt the hood.

To avoid injury before starting and running the engine,

ensure the vehicle is parked on a level surface, parking

brake is set, and the wheels are blocked.

2. Remove the #2 cylinder head cover.

3. Disconnect the electrical connector.

4. Remove the fasteners that attach the pressure/temperature sensor, then remove the sensor.

Install the charge pressure/temperature sensor as follows:

1. Install the pressure/temperature sensor. Tighten the fasteners 10 N·m (7 lb·ft).

2. Connect the electrical connector.

3. Install the #2 cylinder head cover.

4. Lower the hood and remove the chocks from the rear tires.

All information subject to change without notice.

www.rtrucks.ru

Charge Pressure/Temperature Sensor Removal

PERSONAL INJURY

Charge Pressure/Temperature Sensor Installation

www.rtrucks.ru

MBE 4000 SERVICE MANUAL

www.rtrucks.ru

Table of Contents