Detroit Diesel MBE 4000 Service Manual page 59

www.rtrucks.ru
Head and gasket must be seated properly, or engine damage
could result.
3. Using a dial caliper, measure the length of the cylinder head bolts from the end of the bolt
to the bottom of the flange. See Figure 1-6. Listed in Table 1-3 are the acceptable lengths.
Replace any bolts which do not meet these specifications.
1. Dial Caliper
2. End of Cylinder Head Bolt
Figure 1-6
Description
Shaft length when new
Maximum shaft length
Table 1-3
4. Lubricate the cylinder head bolts with engine oil.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
NOTICE:
Measuring Head Bolts
Cylinder Head Bolt Lengths
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
3. Bottom of Flange
Length
210.0 mm (8.27 inches)
212.0 mm (8.35 inches)
www.rtrucks.ru
1-11
www.rtrucks.ru