Detroit Diesel MBE 4000 Service Manual page 274

2.6 PROTECTIVE SLEEVE
www.rtrucks.ru
1. Disconnect the electrical connector. See Figure 2-17.
1. Crank Angle Position Sensor
2. Electrical Connector
Figure 2-17
2. Remove the sensor from the access hole in the flywheel housing.
3. Install a new sensor in the flywheel housing.
4. Connect the electrical connector.
NOTE:
Be sure that the correct electrical connector is connected to the sensor.
2-28
www.rtrucks.ru
Crank Angle Position Sensor Installation
www.rtrucks.ru
3. Flywheel Housing (Timing Case)
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru