www.rtrucks.ru
1. Using a dial caliper, measure the length of the M10 retaining bolt from the end of the bolt
to the bottom of the flange. See Figure 2-12. The acceptable lengths are listed in Table 2-1.
Replace any bolt which does not meet these specifications.
1. Dial Caliper
2. End of Retaining Bolt
Figure 2-12
Description
Shaft length when new
Maximum shaft length
Table 2-1
2. Lubricate a new nozzle O-ring with a light coating of engine oil and install it on the nozzle.
3. Install a new seal ring on the nozzle.
NOTE:
Take care that the nozzle is installed correctly and is aligned properly with respect to the
transfer tube.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Measuring the Retaining Bolt
M10 Retaining Bolt, Length
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
3. Bottom of Flange
Length, mm (in.)
90.0 mm (3.54 inches)
91.0 mm (3.58 inches)
www.rtrucks.ru
2-21
www.rtrucks.ru