1.8
REAR RADIAL SEAL
www.rtrucks.ru
1.8
REAR RADIAL SEAL
A Kent-Moore tool, the Rear Seal Installer and Receptacle (J 45393 or 457 589 02 15 00) is
required for this procedure.
1.8.1
Rear Radial Seal Removal
Remove the rear radial seal as follows:
1. Remove the flywheel. Refer to section 1.12.1. See Figure 1-39.
1. Flywheel
2. Rear Radial Seal
Figure 1-39
1-54
www.rtrucks.ru
Rear Radial Seal Location
www.rtrucks.ru
3. Flywheel Housing
4. End of Crankshaft
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru