1.17
PISTON, PISTON RING, AND CONNECTING ROD
www.rtrucks.ru
[a] Place each ring squarely into the combustion area of a cylinder liner or cylinder, then
measure the end gap, using a feeler gauge. See Figure 1-91.
Figure 1-91
[b] Remove the spring garter from the third (lowest) ring, then measure its gap in the
same way as the other two rings.
1-118
www.rtrucks.ru
Checking the Ring End Gap
www.rtrucks.ru
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru