Detroit Diesel MBE 4000 Service Manual page 476

®
7.7 HENGST BREATHER FILTER
www.rtrucks.ru
2. Unsnap the filter cap and remove the spring and diaphragm insert from centrifugal filter.
Remove the two assembly bolts from the breather filter assembly, and pull the breather
assembly out. See Figure 7-45.
1. Filter Cap
2. Spring and Diaphragm
3. Centrifugal Filter
Figure 7-45
3. Remove the three plastic clamps holding the breather piping to the bracket. Remove the
piping. See Figure 7-44.
4. Remove the two bolts from the air compressor and the block that are holding the piping
bracket on. Remove the piping bracket.
5. Remove the three M8 x 35 mm bolts holding the breather filter to the timing case.
6. Remove the two M8 x 25 mm bolts holding the breather filter to the block.
7. Remove the breather filter.
7.7.2 Installation of Hengst Filter
Perform the following steps to install the Hengst filter:
7-56
www.rtrucks.ru
Hengst Filter Assembly
www.rtrucks.ru
4. Breather
5. Assembly Bolt
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru