Detroit Diesel MBE 4000 Service Manual page 418

6.3 TURBOCHARGER
www.rtrucks.ru
[b] Install the mounting bolts through the holes in the end flange and the heat shield
bracket. Tighten them 25 N·m (18 lb·ft).
[c] Install two new seal rings on the banjo fitting at the other end of the supply line.
[d] Install the banjo bolt attaching the supply line to the cylinder block. Tighten the
bolt 35 N·m (26 lb·ft).
7. Attach the air intake elbow to the turbocharger. Tighten the clamp 10 N·m (7 lb·ft).
8. Attach the turbocharger outlet pipe to the turbocharger. Tighten the clamp 6 N·cm (4 lb·ft).
9. Connect the exhaust pipe to the exhaust brake valve housing.
10. Install the air line on the exhaust brake cylinder, as removed.
11. Install the air cleaner.
Diesel engine exhaust and some of its constituents are
known to the State of California to cause cancer, birth
defects, and other reproductive harm.
Always start and operate an engine in a well ventilated
area.
If operating an engine in an enclosed area, vent the
exhaust to the outside.
Do not modify or tamper with the exhaust system or
emission control system.
12. Start the engine and allow it to run at idle speed for three to four minutes before
accelerating.
13. Check for oil leaks. Correct any if found.
14. Lower the hood and remove the chocks from the rear tires.
6-16
www.rtrucks.ru
www.rtrucks.ru
PERSONAL INJURY
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru