Detroit Diesel MBE 4000 Service Manual page 159

www.rtrucks.ru
3. Install the piston rings on the piston. See Figure 1-84. Refer to section 1.17.3.
1. Piston
Figure 1-84
[a] Lubricate the piston with a light coating of clean engine oil.
[b] Install each piston ring in the appropriate groove on the piston.
4. Offset the ring gaps alternately by 120 degrees.
5. Position a ring compressor loosely over the piston. Tighten the ring compressor on the
piston.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Ring Gaps Offset 120 Degrees
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
1-111
www.rtrucks.ru