Detroit Diesel MBE 4000 Service Manual page 178

1.17 PISTON, PISTON RING, AND CONNECTING ROD
www.rtrucks.ru
9. Set the caliper (internal measurement 80 to 100 mm) to the nominal bearing-journal
diameter calculated above. Use a 75 to 100 mm micrometer for the setting. Preload the
setting 5 mm (0.2 inch). See Figure 1-101.
Figure 1-101
10. Using a quick-release caliper (internal measurement 80-120 mm), dial gauge, and holder,
measure the inside diameter of the bearing bore (with the shells installed) at three points.
1-130
www.rtrucks.ru
Setting the Caliper
www.rtrucks.ru
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru