Detroit Diesel MBE 4000 Service Manual page 443

www.rtrucks.ru
There is a front and rear exhaust manifold gasket and the rear
gasket is marked with a deep notch on top. The front gasket
must be installed before the rear gasket can be installed.
NOTE:
At this point, the heat exchanger and heat exchanger mounting bracket should be
installed on the block, but the remaining exhaust manifold installation graphics will not
show these two parts installed.
NOTE:
The exhaust manifold gasket studs are to be removed after installing the EGR cooler
support bracket.
2. Install stud with M8 nut with collar onto exhaust manifold center piece. Do not tighten nut
at this point.
NOTE:
Stud must be installed on exhaust manifold center piece before fitting the two end pieces
of manifold into center piece.
1. Stud
2. M8 Nut with Collar
Figure 7-15
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
NOTICE:
Installing Stud in Exhaust Manifold Center Piece
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
3. Exhaust Manifold Center Piece
www.rtrucks.ru
7-23
www.rtrucks.ru