Detroit Diesel MBE 4000 Service Manual page 228

1.22 CAMSHAFT AND CAMSHAFT SENSOR
www.rtrucks.ru
1.22.3 Camshaft Sensor Replacement
Replace the camshaft sensor as follows:
1. Disconnect the electrical connector. See Figure 1-137.
1. Camshaft Sensor
Figure 1-137
2. Remove the sensor from the access hole in the flywheel housing.
3. Install a new sensor in the flywheel housing.
4. Connect the electrical connector.
NOTE:
Be sure that the correct electrical connector is connected to the sensor.
1-180
www.rtrucks.ru
Camshaft Sensor Installation
www.rtrucks.ru
2. Crank Angle Position Sensor
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru