Detroit Diesel MBE 4000 Service Manual page 137

Hide thumbs Also See for MBE 4000:

Table of Contents

www.rtrucks.ru

To avoid injury from a falling flywheel when removing the

last bolt, hold the flywheel against the crankshaft by hand

to prevent it from slipping off the crankshaft. The flywheel

is not doweled to the crankshaft.

To avoid injury from a falling component, ensure a proper

lifting device is used.

7. Remove the remaining eight flywheel bolts.

8. Remove the engine cranking tool (J 46167 or 407 589 00 63 00). Refer to section 1.15.1.

9. Remove the flywheel, leaving the guide studs (904 589 02 63 00)in place. See Figure 1-65.

[a] On opposite sides of the bolt circle, screw a bolt into each of two threaded clutch

[b] Using the two bolts as handles, dislodge the flywheel from the crankshaft flange and

remove it from the flywheel housing.

[c] After removing the flywheel, remove the bolts from the clutch bolt holes.

All information subject to change without notice.

www.rtrucks.ru

FALLING FLYWHEEL

FALLING COMPONENT

www.rtrucks.ru

MBE 4000 SERVICE MANUAL

www.rtrucks.ru

www.rtrucks.ru

Chapters

Table of Contents