1.17
PISTON, PISTON RING, AND CONNECTING ROD
www.rtrucks.ru
1. Position the connecting rod in the piston so that the longer end side is on the unit pump side
(left side), and the arrow on the crown of the piston points toward the front of the engine.
2. Install the wrist pin in the piston. See Figure 1-83.
1. Piston
Figure 1-83
[a] Lubricate the wrist pin with a light coating of clean engine oil.
[b] Insert the wrist pin into the wrist pin bore.
[c] Secure the wrist pin with the two snap rings.
1-110
www.rtrucks.ru
Installing the Wrist Pin
www.rtrucks.ru
2. Wrist Pin
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru