www.rtrucks.ru
13. With the cooler completely loosened at this point, pull the cooler housing flange away
from the EGR control valve. As the cooler is lifted, slide the cooler inlet pipe up through
the opening in the cooler support bracket. See Figure 7-23.
1. Cylinder Heads
2. EGR CoolerTightening Clamps
3. Tightening Tool for Clamps
Figure 7-23
NOTE:
Before removing the eight bolts from the EGR cooler support, insert the four guide studs
into the exhaust manifold gasket holes to support the gaskets once the cooler support is
removed.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Removing EGR Cooler
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
4. EGR Cooler
5. EGR Cooler Support
www.rtrucks.ru
7-31
www.rtrucks.ru