Protective Sleeve - Detroit Diesel MBE 4000 Service Manual

www.rtrucks.ru
2.6

PROTECTIVE SLEEVE

Perform the following procedures for removal and installation of the protective sleeve.
2.6.1
Remove the protective sleeve as follows:
To avoid scalding from the expulsion of hot coolant, never
remove the cooling system pressure cap while the engine
is at operating temperature.
clothing (face shield, rubber gloves, apron, and boots).
Remove the cap slowly to relieve pressure.
1. Drain the engine coolant into a clean container. If the coolant is clean, save it for later use.
2. Remove the injector nozzle.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Protective Sleeve Removal
HOT COOLANT
www.rtrucks.ru
Wear adequate protective
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
2-25
www.rtrucks.ru