Detroit Diesel MBE 4000 Service Manual page 103

www.rtrucks.ru
2. Protect the crankshaft with a rag, then using a screwdriver, press out the radial seal.
See Figure 1-40.
1. Rear Radial Seal
2. End of Crankshaft
Figure 1-40
1.8.2
Install the rear radial seal as follows:
NOTE:
The radial seal does not need to be lubricated.
1. Inspect the contact surface of the flywheel for damage and wear. If it is scored or worn,
replace it.
2. Place the receptacle,(J 45393 or 457 589 02 15 00), on the end of the crankshaft. Put
the new radial seal in place on the rear seal installer, (J 45393 or 457 589 02 15 00).
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
Removing the Rear Radial Seal
Rear Radial Seal Installation
www.rtrucks.ru
3. Heavy Cloth
4. Screwdriver
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
1-55
www.rtrucks.ru