3.7
OIL HEAT EXCHANGER AND FILTER HOUSING
www.rtrucks.ru
3.7
OIL HEAT EXCHANGER AND FILTER HOUSING
Perform the following procedures for removal and installation of the oil heat exchanger and
filter housing.
3.7.1
Oil Heat Exchanger and Filter Housing Removal
Remove the oil heat exchanger and filter housing as follows:
To avoid scalding from the expulsion of hot coolant, never
remove the cooling system pressure cap while the engine
is at operating temperature.
clothing (face shield, rubber gloves, apron, and boots).
Remove the cap slowly to relieve pressure.
1. When the engine is cool, drain the coolant from the radiator.
2. Remove the turbocharger from the engine.
3. Disconnect the coolant pump shunt line from the coolant pump inlet pipe and move
it out of the way.
4. Remove the oil filter cap. Inspect the O-ring and filter for damage and replace them if
necessary. Drain the oil remaining in the filter into a clean container.
5. Disconnect the wiring harness from the oil pressure/temperature sensor.
3-26
www.rtrucks.ru
www.rtrucks.ru
HOT COOLANT
Wear adequate protective
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru