www.rtrucks.ru
2. Loosen and remove outside nut that is resting on outside face of stud bracket.
See Figure 7-7.
1. Stud Bracket
2. Stud Nut
Figure 7-7
3. Loosen center nut on stud that is resting on the inside, against the intake manifold center
piece. See Figure 7-7.
NOTE:
If the inside nut that rests against the stud bracket is NOT loosened or moved at this
point, it is possible that the stud dimension adjustment will remain the same without
needing further adjustment when reinstalled.
NOTE:
Stud and stud bracket should be loose enough to allow removal of the exhaust manifold
inlet pipe.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Removing Stud from Exhaust Manifold and Inlet Pipe
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
3. Stud
2. Exhaust Gas Inlet Pipe (Hot Pipe)
www.rtrucks.ru
7-15
www.rtrucks.ru