Detroit Diesel MBE 4000 Service Manual page 75

www.rtrucks.ru
5. Remove and discard the two O-rings from the block. See Figure 1-17.
1. Block
2. Cylinder Liner
3. Collar Seat Insert
Figure 1-17
6. Thoroughly clean the cylinder liner and the collar seat.
NOTE:
Take special care to clean the liner collar and the seating surfaces for the collar seat
insert and the two O-rings.
7. Check the condition of the cylinder liner collar. Make sure that the height of the collar is
within the specifications given. Discard the liner if the collar is not within specifications
listed in Table 1-8.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Cylinder Liner O-rings
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
4. Upper O-ring
5. Lower O-ring
www.rtrucks.ru
1-27
www.rtrucks.ru