Engine Cranking Tool - Detroit Diesel MBE 4000 Service Manual

Hide thumbs Also See for MBE 4000:

Table of Contents

ENGINE CRANKING TOOL

www.rtrucks.ru

A special tool is required for this procedure: Engine Cranking Tool (J 46167 or 407 589 00 63 00).

The engine cranking tool (J 46167 or 407 589 00 63 00) is used for two separate functions:

blocking and cranking.

With the pin inserted, the tool blocks the flywheel ring gear to prevent rotation during

removal and installation of the flywheel.

Without the pin, the tool can be used with a wrench to turn the flywheel and crankshaft

The first time an engine cranking tool is installed on the engine to turn the flywheel, the

teeth on the rotating gear may rub on the flywheel housing. This does not cause a

problem and should not occur the next time the tool is used.

Engine Cranking Tool Installation

Install the engine cranking tool (J 46167 or 407 589 00 63 00) as follows:

1. Remove the two bolts holding the inspection cover to the flywheel housing.

See Figure 1-77.

1. Inspection Cover

2. Remove the pin from the engine cranking tool (J 46167 or 407 589 00 63 00).

www.rtrucks.ru

Engine Cranking Tool Installation

www.rtrucks.ru

All information subject to change without notice.

www.rtrucks.ru

Table of Contents