Detroit Diesel MBE 4000 Service Manual page 406

6.1 INTAKE MANIFOLD
www.rtrucks.ru
4. Remove the mounting bolts attaching the manifold to the cylinder heads.
5. Move the manifold out enough to expose the sensor attached to the back of the manifold.
Disconnect the electrical connector from the socket on the charge air pressure/temperature
sensor. See Figure 6-2.
1. Electrical Connector
2. Intake Manifold Pressure/Temperature Sensor
Figure 6-2
6. Remove the charge air manifold from the cylinder heads.
7. Remove the charge air manifold gaskets. Clean any bits of sealant material from the
manifold and the mating surfaces on the cylinder heads.
6.1.2 Intake Manifold Installation
Install the intake manifold as follows:
1. Place new manifold gaskets on the heads.
2. Connect the electrical connector to the charge air pressure/temperature sensor.
3. Install the manifold on the cylinder head. Tighten the mounting bolts 40 N·m (30 lb·ft).
4. Install the engine trim cover side panels, as removed.
5. Install the charge air inlet pipe, with a new gasket, on the charge air manifold.
6. Lower the hood and remove the chocks from the rear tires.
6-4
www.rtrucks.ru
Sensor Removal
www.rtrucks.ru
3. Sensor Mounting Bolt
4. Intake Manifold
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
All information subject to change without notice.
www.rtrucks.ru