Detroit Diesel MBE 4000 Service Manual page 339

www.rtrucks.ru
3. Install the heat exchanger housing on the cylinder block. Install the housing bolts and
tighten them in the order shown in see Figure 3-22. Tighten each bolt 60 N·m (44 lb·ft).
Figure 3-22
[a] Clean the mating surfaces of the heat exchanger housing and the cylinder block.
Remove any bits of adhering gasket material.
[b] Replace the heat exchanger housing gasket.
All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION
www.rtrucks.ru
www.rtrucks.ru
Tightening Pattern, Heat Exchanger Housing Bolts
www.rtrucks.ru
MBE 4000 SERVICE MANUAL
www.rtrucks.ru
3-29
www.rtrucks.ru